1.ZnO thin films can be deposited by various methods, such as sputtering, e-beam evaporation, spray pyrolysis, sol-gel, pulsed laser deposition (PLD), metalorganic vapor phase epitaxy (MOVPE), molecular beam epitaxy (MBE), atomic layer epitaxy (ALE), etc.
制备ZnO薄膜的方法有很多，包括：溅射方法(sputtering)、金属有机气相外延(MOVPE)、分子束外延(MBE)、脉冲激光沉积(PLD)、原子层外延(ALE)、等离子体加强化学气相沉积(PECVD)、溶胶-凝胶法(soll-gel)、喷涂热解法(spray pyrolysis)、电子束蒸发法(e-beam evaporation)等等。
2.c BN films were deposited on single crystal Si(100) substrates using active reaction evaporation(ARE) technique, in which pure boron was evaporated by electronic beam, the growing film was simultaneously bombarded by energetic ions in radio frequency plasma discharge of nitrogen and argon.
用ARE（Active Reaction Evaporation） 装置， 在N2／Ar 混合等离子体弧光放电气氛下， 通过电子束蒸镀纯硼， 同时伴以一定能量的正离子轰击生长的膜表面的方法， 在单晶硅（100） 基片上成功地合成了立方氮化硼（Cubic Boron Nitride ， 简称c?BN） 薄膜， 并对基片射频自偏压和等离子体弧光放电电流对c?BN 膜形成的影响进行了研究。
3.The results indicate that the evaporation of naphtha is notably influenced by wind speed and evaporation area when the wind speed is low and evaporation area is small, influence becomes weak with the increase of wind speed and evaporation area, which shows the evaporation process for naphtha is controlled by boundary layer evaporation at some degree.
实验结果表明，石脑油在低风速和液面面积较小的情况下，石脑油的蒸发受风速和液面面积的影响明显，增加风速或增大液面面积后，影响减弱。
4.The application and features of vaccum strip coating processes such a thermal jet evaporation, magnetron sputtering, electron-beam evaporation and plasma enhanced EB evaporation process were reviewed.
摘要介绍了新一代连续带钢镀膜技术－真空镀膜的工艺特点及应用现状。
5.The dynamic characteristics of evaporation process for naphtha and crude oil were researched in three aspects of different wind speed, evaporation area and relative location of evaporation surface to ground in wind tunnel.
摘要从环境风速、蒸发面积和蒸发液池与地面相对位置3方面分别对石脑油和原油的蒸发动力学特性进行了风洞实验研究。
6.During summer fallow, the anti-evaporation rate of NTS was 12.87%, and 18.32% higher than those of CTS and CTB, respectively (P
在夏季休闲期,NTS的抑制蒸发率比CTS和CTB分别提高12.87%和18.32%(P
7.When water in the soil or in the xylem is put under tension, due to the evaporation of water from a particular site(which creates a water potential gradient in the direction of the evaporation), capillarity enables water to overcome the cohesive forces within the water and move against gravity in response to the water potential gradient.
当土壤中或木质部中的水受到张力作用时，由于特定部分水的蒸发（沿着蒸发方向形成水势梯度），毛细现象可以使水克服水分子之间的内聚力并同时沿着水势梯度逆着重力作用移动。
8.With a project examples, calculates the latent heat by pool water evaporation, and concludes that the pool water evaporation is an important factor influencing air conditioning load.
结合工程实例，计算了池水蒸发潜热量，得出池水蒸发潜热负荷是空调负荷的一个重要影响因素。
9.The results show that the exhaust fan current increases with frosting enhancement, while the increasing speed gets slower in the end of frosting, and the curves of current are slightly different at different voltages; that the evaporation temperature decreases with frosting enhancement, and the decreasing speed becomes increasingly faster; and that misoperation of defrosting can be avoided by using the intelligent defrosting control method based on exhaust fan current combined with evaporation temperature presented according to the experimental results.
结果表明，排风机电流随结霜厚度的增加而增大，增加速率在结霜后期趋缓，不同电压下电流变化曲线略有不同；蒸发温度随结霜厚度的增加而降低，下降速度越来越快；使用根据实验结果提出的基于排风机电流和蒸发温度联合控制的智能除霜方法可以基本避免误除霜动作。
10.The results showed that the evaporation loss rate of Al in Ti 48at%Al melt at 2000K is 50 times as large as that of Ti,namely Al will have its preference of evaporation.
结果表明，2000K时，Ti?48at％Al熔体中铝的挥发速率是钛挥发速率的50倍左右，即铝优先挥发。
